PMD Pro Personal Microderm Device

1. Thoroughly cleanse your skin. Make sure that it is free from all make up, dirt, and oils. We recommend using the PMD Advanced Soothing Cleanser, since it is specifically formulated to work with the PMD device and treatments.
2. Once the skin is clean, allow it to dry completely before you begin. A dry skin surface is particularly important because it allows the Microdermal Exfoliator to work properly and effectively. If the skin is damp or clammy, the disc will be unable to smoothly glide over it.
3. Connect the power cord to the device. Turn the connector one quarter turn until it locks in place. Insert a disc. Push the disc down firmly on the device post. Twist on cap, making sure to tighten the cap firmly against the black o-ring on the device. Check to make sure the disc is sitting slightly below the plastic cap.
4. On the first treatment, use the training disc on the neck to test how the skin will react to treatments from the personal microderm. This step does not need to be repeated beyond the first treatment.
5. Use a free hand to pull the skin tight in the treatment area. Move the PMD Personal Microderm in an upward motion across the skin. Do not make more than two passes over one area during treatment.
6. Following the treatment, use a toner to neutralize the pH balance of the skin and a recovery moisturizer. Let your skin recover. Wait 6-7 days between treatments.

To clean: Remove cap by twisting counter-clockwise. Pull disc straight off. Pull out dark filter. Clean the cap and the disc with rubbing alcohol or an antibacterial soap. Clean the filter by running warm water over it and rubbing it between your fingers and thumb. Always remember to place the filter back in the device. For best results, replace the discs every 2-4 treatments.